[IowaNv200]

I want to add a 2nd battery....How to get power wire through the firewall (US Version).

I don't want to drill holes or go through the fender/wheel well. I would love to have both batteries in the engine compartment, then run the aux power wires into the cab, but I can live with the battery in the cargo area.

 

[GLJoneson]

I ran mine through the fire wall , at the or below the steering Colum, I have a U.S. version of the van

 

[IowaNv200]

I ran mine through the fire wall , at the or below the steering Colum, I have a U.S. version of the van

Did you have to do any drilling or moving of carpet. How big was the hole/grommet? Last time I looked, I saw a huge grommet above the column and somewhere near the fuse panel in the dash. I didn't check to see if I could get a wire though it. Do you have any photos of the install? What year is the NV200?

 

[GLJoneson]

That is where It went,, I have no carpet in my van it has only a rubber mat, I used 1/0 cable for my leads

 

[Zooom]

In the european version there is a blind hole underneath hood release cable. A rubber plug, easily to be taken out, leads right through. We use that for all of the wiring we install AC/DC.
Just check if there is anything similar in the US version.

Regards,
Thomas

 

[rodge33]

In the european version there is a blind hole underneath hood release cable. A rubber plug, easily to be taken out, leads right through. We use that for all of the wiring we install AC/DC.
Just check if there is anything similar in the US version.

Regards,
Thomas

En français peut être ?
Merci

Envoyé de mon GT-P5220 en utilisant Tapatalk

 

[jerryww865]

I have a U S 2016 mine had hole with rubber plug under drivers seat. I ran #4 cable to two battery. Ran the gr cable to the seat mount bolt. Works great both battery are just at the drivers seat.