NV200 Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
If I am not mistaken, to install a roof top fan in the NV200, requires a 12" or 13" fan to avoid cutting into the structural supports? Does anyone know of a fan that is smaller than the 14" Fantastic, but that still has a low profile. Thanks..Roger
 

· Registered
Joined
·
16 Posts
If I am not mistaken, to install a roof top fan in the NV200, requires a 12" or 13" fan to avoid cutting into the structural supports? Does anyone know of a fan that is smaller than the 14" Fantastic, but that still has a low profile. Thanks..Roger


Hi Roger

Just wondering if you managed to source a fan or come up with another way that fitted these dimensions and any pics?


Sent from my iPhone using Tapatalk
 

· Registered
Joined
·
41 Posts

· Registered
Joined
·
3 Posts
Solor powered vent fan

If I am not mistaken, to install a roof top fan in the NV200, requires a 12" or 13" fan to avoid cutting into the structural supports? Does anyone know of a fan that is smaller than the 14" Fantastic, but that still has a low profile. Thanks..Roger
I have seen this recommended in another forum and I was planning on using this in my conversion. I am trying to avoid all wiring so solar power is the way to go for me, not sure if it will work for you.

http://www.marinco.com/en/n20704w
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top