NV200 Forum banner

NV200/Juke/Qashqai leather seats

575 Views 3 Replies 2 Participants Last post by  sray53txtn
Hi all.
Like a previous member on here, I am trying to find out if its possible to install Juke or Qashqai leather seats into an NV200 van. Putting the wiring issues to one side, does anybody know if the bolt pattern is the same for the runners on the seat base? I believe the sensors attached to the seat may need some investigation to wire them correctly but I'm an electrician so I'm confident I could figure that out.
Cheers
Dean
1 - 4 of 4 Posts
I don't know if it'd be a exact fit, however, I have a 2019 NV200 and a 2018 Rogue Sport (Qashqai ) on which I could take some measurements. Mine are US versions, one would think floor pan and seat specs would be similar.
I don't know if it'd be a exact fit, however, I have a 2019 NV200 and a 2018 Rogue Sport (Qashqai ) on which I could take some measurements. Mine are US versions, one would think floor pan and seat specs would be similar.
Good morning, that would be good if you dont mind doing that. At some point I'm going to take my passenger seat out so I can accurately measure and view the workings.
Thanks so much
Dean
Good morning, that would be good if you dont mind doing that. At some point I'm going to take my passenger seat out so I can accurately measure and view the workings.
Thanks so much
Dean
Just did a quick check of drivers seat attachment measurements (center to center of attaching bolts - close as possible without removing seat) and it does not look good:
2018 Rogue Sport (Qashqai )
Width 16" 40.64cm
Length 15.75" 40cm

2019 NV200
Width 15.5" 39.37cm
Length 22.25" 56.15cm

Floor pan mounting profiles are quite different as well. Again these are US spec vehicles, not sure how different they may be.
You could possibly contact a local body repair shop to see if they could provide the seat attachment/floor pan measurement specs on an England Qashqai version.

Hope that helps.
See less See more
1 - 4 of 4 Posts
Top